For more information on the Kardon Wallet click here.
Putting Cards In:
There are multiple ways to put cards into the wallet. The best way to load multiple cards is to rotate the top piece of the wallet to 90° or greater, then grasp the top piece firmly and press on the screw head and insert desired cards.
An alternate method when inserting one cart is to push the card partially into the front of the wallet (flat narrow side) until you feel a slight resistance. After that, wedge your fingers in between the top piece and bottom piece then press on the head of the screw and slide the card in.
Taking Cards Out:
Again, there are many ways to take a card out. The way we recommend is as follows: using only your dominant or dominant and non-dominant hands, place your hand(s) underneath the wallet with your dominant pointer finger on the side of the wallet and your thumb(s) on the top of the wallet. Then, apply lateral force with your thumb(s) to the top of the wallet to rotate the top.
You can, preferably with your non-dominant hand, arrange your cards to where all or your desired car is accessible. Once desired card is accessible place your pointer finger on the underneath of the top piece of the wallet, your thumb on the screw head, and the rest of your fingers on the bottom of the wallet. Apply light pressure to the underneath of the top piece and screw head to allow cards to remove easily and reinstall easily. Pull the desired car from the wallet and, when ready, reinsert the card back into the wallet. Please note that if there is too much pressure applied with the index finger and thumb cards may fall out easily.
Disassembly & Assembly:
The first step to disassemble the wallet is to release tension by removing all of the cards. Secondly, unscrew the screw counterclockwise. The thread of the screw might need to be heated up. Remove the screw to complete the disassembly.
To reassemble, stack the assembly in the order of bottom piece, top piece, spring, money clip, and then install the screw. Please note that the screw has thread adhesive applied to it during final assembly. Failure to apply thread adhesive might cause the screw to back off over time and may cause damage to the wallet.
